Bowden Clamp(heater end)



 



The clamp at the heater end wasn't holding it, making the tube pop out during print. So I made a fresh part of 8B(looks slightly different from the original) and replaced the white plastic tube clamp with the same part from the extruder end. Now printing the bowden clamp for the heater end(http://www.thingiverse.com/thing:11864). By the way, clamp at the extruder end works very fine. I was lucky that I've just installed the extruder end bowden clamp about a week ago.

튜브가 프린트 헤드 쪽에서 자꾸 빠져 부속품 8B를 회사에서 만들어 왔다. 원래 부품하고는 좀 다르지만 임시로 작동은 하니까.. 8B에 껴있던 플라스틱으로 된 튜브클램프도 익스트루더쪽에 있던 비슷하게 생긴 부품으로 교체하였다. 튜브클램프(http://www.thingiverse.com/thing:11864)를 프린트하고있는데 이제 튜브의 양쪽을 전부 교체하는 때가 드디어 왔구나. 플라스틱 튜브클램프가 튜브를 잘 못물던데 클램프 프린트 안했으면 큰일날뻔했다;

Comments